LED Luminaire Test Solution
For the LED outdoor and indoor design and manufactory, Lisun can supply a full quality control test solution. Please feel free to contact with Lisun Sales Dept for the detail technical solution and formal quotation at: [email protected]
1. Photo, Color and Electricity Test System
LPCE-3(LMS-7000) is according to LM-79 and LM-80, and it is a high accuracy test system which is similar as US and Germany level. The system can test the color parameters such as CCT, CRI, Spectrum, Flux, Flux Efficient, Power, Power Factor, Voltage, Current and so on.
• Integrating Sphere Spectroradiometer System for LED
LPCE-2(LMS-9000) is accepted by many LED luminaire manufactory. It meets LM-79 and LM-80. The system can test the color parameters such as CCT, CRI, Spectrum, Flux, Flux Efficient, Power, Power Factor, Voltage, Current and so on.
2. Goniophotometer System
The Goniophotometer is used to test the intensity distribution curve in 3D and export IES or LDT file for the lighting software such as DiaLux. The Goniophotometric System is according to LM-79, LM-80, IEC and CIE Standards.
3. EMI and EMC Test System
EMI-9KB/EMI-9KA is the EMI Receiver system which are fully meets CISPRl6-1, GB17743, FCC, EN55015 and EN55022. It is used to test the LED driver, LED luminaires and other electronic products. Detection frequency range: 9kHz~300MHz (EMI-9KB) or 9kHz~30MHz (EMI-9KA).
4. Electrical Safety Test
• LED Power Driver Tester: WT2080 is according to GB/T 24825-2009 and IEC 62384:2006. It can measure the following parameters: Input Characteristics Test (AC&DC), Output Characteristics Test (AC&DC), Input Start Characteristics Test (DC).
• Programmable Withstanding Voltage & Insulation Test: LS9923.
5. IP Level Test such as IP56 degree certificate
Waterproof Test: JL-X waterproof test system is according to IEC60529, IEC60598, IEC60335 and IEC 60034-5:2000. The JL-X includes the following test grades: IPX1, IPX2, IPX3, IPX4, IPX5, IPX6, IPX7 and IPX8 (Refer to page 51 of IEC60529). It is widely used in the authentication test organization for the products such as electrical & electronic products such as LED luminaires as well as in the relevant quality control department for the waterproof detection of the enclosures protection grades.
Dustproof test: The Dustproof Test Chamber SC-015 is according to IEC60529, GB2423.37-89 (Test L: dust test methods), GB 4208-93 protective casing grade (IP code), GB/T 4942.2-93(protective casing grade of low-voltage apparatus), GB 7000.1-1996, GB 7001-1986(protective casing grade of lamps), DIN40050 and IP5K0. The SC-015 is applied in LED or other luminaries for IP5X and IP6X test.
6. High and Low Temperature Humidity Chamber: GDJS-*B
The High and Low Temperature Humidity Chamber: GDJS-015A. Lisun special designed based on lighting fixtures temperature aging request. It used the Finland Digital humidity sensor, TEMI controller and water purification system. The GDW/GDJS chamber can work with Lisun LEDLM-80PL to do the LED optical aging test accroding to LM-80 and LM-82